Brunton Shaw

FAQ

E-mail Print

A collection of answers to the questions you ask us the most about BruntonShaw products and services are provided below.

Storing, Handling, Installation and Maintenance of Wire ropes

For information on Storing, Handling, Installation and maintenance of wire ropes refer to the latest editions of

BS EN12385-3. Steel wire ropes - Safety - Part 3: Information for use and maintenance.

ISO 4309 Cranes - Wire ropes - Care and maintenance, inspection and discard.

BSUK publications 'Use and care of wire ropes' & 'Safety Information' ( Click on Links )

Care and Maintenance of Elevator Ropes

Before ropes are installed the sheave grooves should be checked for wear. Worn grooves cause rope damage. This precaution is especially important when worn ropes are being replaced as the grooves may have become worn by the old ropes to a size which is too small to adequately accommodate the new rope. All the ropes on an installation should be equally tensioned, BSUK recommends tensioning between ropes of ± 10%. Unequal tensions result in unequal wear, slipping and premature rope failure. In a new installation, all foreign matter, stone, dust, cement etc should be removed before the ropes are installed.
Lubrication is critical in achieving optimum rope performance, it reduces friction between component parts of the rope, slows the onset of fatigue and helps prevent ’rouging’, however, too little and rope life can be reduced, too much and slip may develop. All BSUK lift ropes are lubricated during manufacture to ensure they contain the correct type and quantity of lubricant for the application. The quantity of lubricant for traction drive ropes is carefully controlled to prevent slip.
Depending on the conditions under which the rope is operating however the lubricant applied during manufacture may not last the life of the rope. Periodic lubrication may therefore be necessary however care should be taken to ensure that the coefficient of friction is not reduced below the value at which slip will occur. Excessive amounts of lubricant should be avoided. Before re-lubricating the rope should be cleaned to remove any debris and contaminated lubricant. After re-lubricating BSUK recommends that rope tensions are checked and adjusted where necessary.

Discard Criteria for Lift Ropes

Discard should not only be determined by wire breaks, other factors such as irregular wear patterns, excessive stretch, reduction in diameter, localised damage corrosion etc. must be taken into account by the competent person when making a thorough examination. Note that a rope with a diameter reduction of 6% or more of the nominal diameter should be replaced immediately. For further information refer to ISO 4344, BS EN 12385 or contact our Field Services Department.

Quality Accreditations

For Information on Quality Accreditations please click on the links below:

Conditions of Purchase

 

Head Office & Factory

Brunton Shaw UK
Sandy Lane
Worksop
Nottinghamshire S80 3ES
UK

Tel: + 44 1909 537600
Fax: + 44 1909 500199
E-mail: info@brunton-shaw.co.uk

Scottish Sales Office

Brunton Shaw UK
Tasman House
Mariner Court
Clydebank G81 2NR
UK

Tel: +44 (0)141 951 8801
Fax: +44 (0)141 951 8802
E-mail: sales@brunton-shaw.co.uk

De Ruiter Staalkabel BV

De Ruiter Staalkabel BV
Kerkeplaat 10
3313LC Dordrecht
The Netherlands  
You are here: Home FAQ